Differences
This shows you the differences between two versions of the page.
|
redsail_cm1080_laser_cutter [2012/12/07 21:53] richardsim |
redsail_cm1080_laser_cutter [2013/03/21 15:44] (current) darls |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Overview ====== | ====== Overview ====== | ||
| - | owner = Vancouver Hack Space\\ | + | Owner = Vancouver Hack Space\\ |
| - | user certification required = YES (see below)\\ | + | User certification required = YES (see below)\\ |
| - | hackable = NO\\ | + | Hackable = NO\\ |
| - | arrived = March 30, 2012\\ | + | Arrived = March 30, 2012\\ |
| - | doesitwork = WORKING - Setup and testing in progress\\ | + | Doesitwork = WORKING - Setup and testing in progress\\ |
| - | if it breaks = Turn off main power, leave water cooler running for 5 minutes and then shut off the Master Power and unplug. Put a BROKEN sign on machine. Notify Members list and Laser Cutter Committee immediately.\\ | + | If it breaks = Turn off main power, leave water cooler running for 5 minutes and then shut off the Master Power and unplug. Put a BROKEN sign on machine. Notify Members list and Laser Cutter Committee immediately.\\ |
| - | contact = Richard Sim or any Laser Cutter Committee member\\ | + | Contact = Richard Sim or any Laser Cutter Committee member\\ |
| - | where = Laser Room\\ | + | Where = Laser Room\\ |
| - | value = $3500 + ~$1000 to get it here and set up | + | Value = $3500 + ~$1000 to get it here and set up\\ |
| + | Work area size = 1000mm x 800mm | ||
Except where otherwise noted, content on this wiki is licensed under the following license:Public Domain
