laser_cutter_settings
Differences
This shows you the differences between two versions of the page.
|
laser_cutter_settings [2012/12/23 21:43] rsim |
laser_cutter_settings [2013/01/11 07:54] (current) desparo |
||
|---|---|---|---|
| Line 48: | Line 48: | ||
| ^ Material ^ Mode ^ Speed ^ Power ^ Corner Power ^ Passes ^ Notes ^ | ^ Material ^ Mode ^ Speed ^ Power ^ Corner Power ^ Passes ^ Notes ^ | ||
| | Acrylic - 1/16" | Cut | 25 | 15 | 15 | 1 | Trying to etch with the cut setting. The outline is visible but not great. | | | Acrylic - 1/16" | Cut | 25 | 15 | 15 | 1 | Trying to etch with the cut setting. The outline is visible but not great. | | ||
| + | | Hard Board - 1/4" | Cut | 1 | 80 | 70 | 2 | Needed 2 Passes Burned edges. Looks really really bad | | ||
| + | | Hard Board - 1/4" | Cut | 8 | 50 | 45 | 9+ | The material has significant burns around the edge after so many passes | | ||
| ==== FURTHER INFORMATION ==== | ==== FURTHER INFORMATION ==== | ||
laser_cutter_settings.txt · Last modified: 2013/01/11 07:54 by desparo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: Public Domain
